What do I do if my Amulet screen is blank and looks dead?

Follow the steps below for color:

1. Disconnect power and flip PROG/RUN switch down to the OFF position.
2. Reconnect power and serial cable, screen should be blank.
3. Open GEMstudio and go to File -> Restore Amulet OS
4. Flip PROG/RUN switch back up into the ON position, press reset on the RS232 board (or on any of the controller boards).
5. You should now see the touch screen calibration, and after hitting the 3 targets you should be able to program your project.

Follow the steps below for monochrome:

1. Disconnect power and flip dip 1 on the RS232/PIB-1 board down to the OFF position.
2. Reconnect power and serial cable, screen should be blank.
3. Open your HTML Compiler and go to File -> Restore Amulet OS
4. Flip dip 1 back up into the ON position, press reset on the RS232 board (or on any of the controller boards).
5. You should now see the touch screen calibration, and after hitting the 3 targets you should be able to program your project.